Auerswald COMpact 3000 analog Installation, Operation And Configuration Instructions page 392

Configuring and Managing the PBX
ISDN Connection
Entering Telephone Numbers for the ISDN Point-to-Point Connection
– Configured prefixes (country prefix and local area code)
1. Open the page CONFIGURATION > External numbers.
2. In the list field at the top, select the ISDN connection in question.
A page opens for configuring the ISDN connection.
3. Open the page ISDN connection > Telephone numbers.
Note: The entry is also provided during the quick configuration using the
configuration wizard.
4. In the PBX base number entry field, enter the PBX base number (serial, head, basis
telephone number) that belongs to the connected network termination unit according
to the order confirmation of the network provider.
Up to 20 digits
Digits
5. In the From entry field under Direct dialling in (DDI), enter the digit sequence you
received from your computer network provider. The following entries are possible:
Up to 4 digits
Digits
6. In the entry field Name, enter a name for the telephone number. The following entries
are possible:
Up to 16 digits
Digits and characters
Note: The name is used for display purposes on the system telephone.
7. Click .
8. Repeat step 3 to 5 to enter additional telephone numbers.
Further steps:
– Save your settings before you leave the page.
392
COMpact 3000 analog/ISDN/VoIP - Firmware Version 4.0 - Version of the Manual 03 02/11