Removing The Cover Panel - Auerswald COMpact 3000 analog Installation, Operation And Configuration Instructions

Installing and Switching on the PBX
Preparation

Removing the Cover Panel

Removing the Cover Panel
Warning: Touching voltage-carrying conductors or telephone connections
may cause a life-threatening electric shock.
• Remove the power plugs – if connected – for both the PBX and all acces-
sories from the power socket before you open the casing.
• If necessary, also disconnect the devices from auxiliary power sources
(e. g. UPS).
Warning: Power surges, which can occur during electrical storms, can
cause life-threatening electric shocks.
• Do not open an already connected PBX during an electrical storm.
1. Grasp the cover panel from below (under the rim) to the left and right with the fingers
of both hands. Place the thumbs in the middle section next to the LED display.
2. Pull the cover panel away from the chassis slightly on both sides to unlatch the
locking.
The figure below shows the position of the hands on the cover panel and the direction
in which you have to pull the panel.
3. Lift the upper cover panel vertically off the casing. To support this action, press with
the thumbs against the casing.
COMpact 3000 analog/ISDN/VoIP - Firmware Version 4.0 - Version of the Manual 03 02/11
39