Configuring The Type Of Clip Information; Configuring The Clip Sub-Version - Auerswald COMpact 3000 analog Installation, Operation And Configuration Instructions

Configuring and Managing the PBX
Analog Connection

Configuring the Type of CLIP Information

Configuring the Type of CLIP Information
The CLIP information type indicates whether and how the analog network provider sends the
CLIP information.
The configuration can be made as follows:
• Via the configuration manager
Requirements:
– External analog port (only COMpact 3000 analog)
– CLIP service attribute enabled with the network provider (telephone number display)
– Configuration manager, opened with sufficient authorization
– Expert view (click
– Configured prefixes (country prefix and local area code)
1. Open the page CONFIGURATION > External numbers.
2. In the list field at the top, select the analog connection.
A page opens for configuring the analog connection.
3. Open the page Analogue connection > Expert configuration.
4. In the Type of CLIP information list field under CLIP, select one of the following
options:
no: The network provider sends no CLIP information.
FSK: The network provider sends the CLIP information via frequency shift
keying.
DTMF and DTMF (MaxComm): The network provider sends the CLIP infor-
mation via dual tone multi frequency.
Further steps:
– Save your settings before you leave the page.

Configuring the CLIP Sub-version

The CLIP sub-version indicates when the analog network provider sends the CLIP information.
The configuration can be made as follows:
• Via the configuration manager
COMpact 3000 analog/ISDN/VoIP - Firmware Version 4.0 - Version of the Manual 03 02/11
)
381