Configuring The Ringer Frequency - Auerswald COMpact 3000 analog Installation, Operation And Configuration Instructions

Configuring and Managing the PBX
Analog Connection

Configuring the Ringer Frequency

2. In the list field at the top, select the analog connection.
A page opens for configuring the analog connection.
3. Open the page Analogue connection > Expert configuration.
4. In the entry fields under Tones, enter the values that you received from the network
provider. The following entries are possible:
Digits and characters
Note:
The tones should only be changed after discussing this with Support.
An incorrect entry can cause malfunctions on the PBX.
Further steps:
– Save your settings before you leave the page.
Configuring the Ringer Frequency
The ringer frequency indicates the frequency the ring signal is transmitted by the analog
network provider.
Note: In German PBX models, the ringer frequency is specified at 25 Hz.
The configuration can be made as follows:
• Via the configuration manager
Requirements:
– External analog port (only COMpact 3000 analog)
– Configuration manager, opened with sufficient authorization
– Expert view (click
– Configured prefixes (country prefix and local area code)
1. Open the page CONFIGURATION > External numbers.
2. In the list field at the top, select the analog connection.
A page opens for configuring the analog connection.
COMpact 3000 analog/ISDN/VoIP - Firmware Version 4.0 - Version of the Manual 03 02/11
)
385