Analog Connection; Entering The Name For The Analog Connection - Auerswald COMpact 3000 analog Installation, Operation And Configuration Instructions

Configuring and Managing the PBX

Analog Connection

Entering the Name for the Analog Connection

Analog Connection
The COMpact 3000 analog provides an external analog port on both the German and interna-
tional PBX models.
On the German PBX models, this analog port has already been configured with the default
settings that are required for analog ports in Germany. When a country is selected, the inter-
national models are automatically configured with the default settings required for analog ports
in the country selected.
In addition, it is possible to change the country-specific settings via the configuration manager.
Entering the Name for the Analog Connection
The name of the analog connection is used for identification purposes. For example, it is shown
for incoming external calls on the display of the internal subscriber (alpha-numeric CLIP-
capable or ISDN subscribers).
The entry can be made as follows:
• Via the configuration manager
Requirements:
– External analog port (only COMpact 3000 analog)
– Configuration manager, opened with sufficient authorization
– Configured prefixes (country prefix and local area code)
1. Open the page CONFIGURATION > External numbers.
2. In the list field at the top, select the analog connection.
A page opens for configuring the analog connection.
3. Open the page Analogue connection > Name and functions.
4. In the Name of the connection entry field, enter the desired name. The following
entries are possible:
Up to 16 digits
Digits and characters
Further steps:
– Save your settings before you leave the page.
360
COMpact 3000 analog/ISDN/VoIP - Firmware Version 4.0 - Version of the Manual 03 02/11