Auerswald COMpact 3000 analog Installation, Operation And Configuration Instructions page 188

Configuring and Operating Functions
Baby Call
Switching Baby Call On/Off
4. In the destination number entry field under Baby call (connection without
dialling), enter the destination number. The following entries are possible:
Up to 20 digits
Exchange line access number + external phone number
Short-code numbers
Internal number of the individual telephone
Internal number of the line group
Further steps:
– Save your settings before you leave the page.
Switching the Baby Call Function On/Off via the Internal Telephone
Requirements:
– Authorization Controlling of the PBX via telephone assigned to the subscriber
1. Pick up the receiver of the telephone in question.
2. Dial one of the following character strings:
*53#: Enables baby call with the existing destination number. (No other action
is required.)
#53#: Disables the baby call. (No other action is required.)
*53*: Enables the baby call.
3. Enter the destination number. The following entries are possible:
** and internal telephone number of the individual telephone (If you do not
use a direct exchange line access, omit the **.)
** and internal telephone number of the line group (If you do not use a
direct exchange line access, omit the **.)
External phone number (If you do not use a direct exchange line access, dial
the exchange line access number before dialling the telephone number.)
** and short code number (If you do not use a direct exchange line access,
omit the **.)
4. Dial #.
188
COMpact 3000 analog/ISDN/VoIP - Firmware Version 4.0 - Version of the Manual 03 02/11