Auerswald COMpact 3000 analog Installation, Operation And Configuration Instructions page 41

Installing and Switching on the PBX
Preparation
Overview of the Connections and Other Device Components
E Depending on the country variant: four TAE sockets or RJ-11 sockets (internal a/
b ports 1-4) for the connection of analog end devices
F Eight terminal clamps (internal a/b port 1-4) for the connection of analog end
devices, two adjoining terminal clamps per port
G Mounting straps for strain relief
H Cable channels including strain relief
I Barrel connector socket for the connection of the power plug
J LED display field to control the operating state
K Variable module slot
View from Below
The following figure shows the components accommodated at the side of the basic
unit (after wall mounting, pointing to the bottom) based on the COMpact 3000 VoIP.
A SD card slot
B One USB socket type A (USB host) for connecting to a printer or a storage
medium
C COMpact 3000 VoIP: two RJ-45 sockets "LAN 1" and "LAN 2" (Ethernet) for
connecting to a PC, VoIP telephone and/or a network
Note: The RJ-45 sockets "LAN 2" and "WAN" have priority over the RJ-45
socket "LAN 1" (Traffic Shaping). Therefore you should preferably use
"LAN 2" for connecting to a VoIP telephone and "LAN 1" for connecting to a
PC.
COMpact 3000 ISDN and analog: one RJ-45 socket "LAN" (Ethernet) for
connecting to a PC, VoIP telephone or a network
D COMpact 3000 VoIP: RJ-45 socket "WAN" (Ethernet) for the connection to a DSL
router
COMpact 3000 analog/ISDN/VoIP - Firmware Version 4.0 - Version of the Manual 03 02/11
41