Switching En-Bloc Dialling On/Off - Auerswald COMpact 3000 analog Installation, Operation And Configuration Instructions

Configuring and Managing the PBX
VoIP

Switching En-bloc Dialling On/Off

Requirements:
– External VoIP channel (COMpact 3000 VoIP or VoIP channels purchased and activated in
the Upgrade Center)
– Configuration manager, opened with sufficient authorization
1. Open the page CONFIGURATION > Voice over IP (VoIP) > VoIP provider.
2. Click in the line of the corresponding VoIP provider.
The Provider configuration opens.
3. Open the page Provider configuration > Network.
4. Select or clear the SIP session timer check box under SIP.
Enables the SIP session timer.
Disables the SIP session timer. (No other action is required.)
5. Enter a value in the Interval for SIP session timer entry field under SIP. The
following entries are possible:
5 to 60: The SIP session timer checks every 5 to 60 minutes to see whether a
connection still exists.
Note: When the SIP session timer is enabled, an increased number of
disrupted calls may occur after the interval configured if a VoIP provider has
not implemented session renewal properly. In this case, you should disable
the SIP session timer.
Further steps:
– Save your settings before you leave the page.
Switching En-bloc Dialling On/Off
If, for example, problems occur in sub-system operation with overlap sending, en- bloc dialling
can permanently be enabled. The digits dialled are transferred en-bloc to the provider in order
to establish a connection after the delay time after last digit dialled.
The delay time after last digit dialled is the amount of time until the PBX detects the end of
dialling. The time measurement restarts after each digit entered. After the configured time has
passed, the PBX detects the digit just dialled as the last digit and allows no further entry..
COMpact 3000 analog/ISDN/VoIP - Firmware Version 4.0 - Version of the Manual 03 02/11
413