Configuring The Pbx Remotely Via The Internet (Externally) - Auerswald COMpact 3000 analog Installation, Operation And Configuration Instructions

Service and Maintenance
Remote Configuration and Alternative Connection Options

Configuring the PBX Remotely via the Internet (Externally)

Remote Configuration on the PBX via the External S
Important: This function is only possible on the COMpact 3000 ISDN or the
COMpact ISDN module available as an option.
The PBX can only be configured remotely over an indirect external ISDN connection on a
device that is not only connected to the external S
controller or Auerswald USB device). The PBX must be configured for this purpose accordingly.
A dial-up connection must also have been previously configured on the PC.
Configuring an ISDN System Telephone via the PBX (Internal)
An ISDN system telephone can be configured via an indirect connection over the PBX. The
configuration software COMfortel Set for the ISDN system telephone must be previously
installed.
Configuring an ISDN System Telephone Remotely via the External S
Important: This function is only possible on the COMpact 3000 ISDN the
COMpact ISDN module available as an option.
An ISDN system telephone can be configured remotely over the PBX and one device that is
connected to both the external S
USB device). The PBX must be configured for this purpose accordingly. The configuration
software for the ISDN system telephone must have been previously installed.
Configuring the PBX Remotely via the Internet (Externally)
Requirements:
– Existing Internet connection between the computer and the PBX (DSL)
– Permanent external IP address, or the use of VPN or DynDNS
– A router configured for this purpose
Note:
Refer to the operating manual of your router.
The access is possible via http: and via https: (encrypted access).
514
port on the PBX and a PC (ISDN PC controller or Auerswald
0
COMpact 3000 analog/ISDN/VoIP - Firmware Version 4.0 - Version of the Manual 03 02/11
Port (PPP External)
0
port on the PBX but also to a PC (ISDN PC
0
Port on the PBX
0