Performing A Restart Due To Errors Via The Sd Card - Auerswald COMpact 3000 analog Installation, Operation And Configuration Instructions

Service and Maintenance
Restart

Performing a Restart Due to Errors via the SD Card

Performing a Restart Due to Errors via the SD Card
Requirements:
– An SD card with current firmware in the root directory
1. Insert the SD card into the SD card slot on the PBX.
2. Restart the PBX via the configuration manager or by pressing a button.
The "Power" LED lights up/flashes in red and orange for up to two minutes.
If the "Power" LED lights up green again, the restart is completed. The PBX runs with
the firmware saved on the SD card.
Note: If the "Power" LED remains continuously lit in red, an error has
occurred. Please contact your dealer or the manufacturer directly.
Further steps:
– Carry out a firmware update back to a functioning firmware version, remove the SD card and
restart the PBX.
COMpact 3000 analog/ISDN/VoIP - Firmware Version 4.0 - Version of the Manual 03 02/11
499