Configuring and Managing the PBX
Call Distribution
Creating Call Distribution
Perform the following steps for each MSN available on the connection (telephone numbers on
the point-to-multipoint connection):
1. Pick up the receiver of the internal telephone on which external calls should ring.
2. Dial ##8.
3. Enter the sub-admin or admin PIN.
4. Dial *901*.
5. Enter an MSN without a prefix.
6. Dial # and do not hang up the receiver.
Any other telephones connected also ring. The fourth telephone jack is meant for the
fax. The device connected does not ring.
7. Pick up the receivers of the telephones that are also supposed to ring for external calls
on this MSN.
You will hear the confirmation tone on each receiver you pick up (pulsating tone).
Note: If a telephone is connected to the fourth telephone jack, instead of the
pre-configured fax machine, you must also pick up that receiver for just a
short time in order to cancel the default setting.
8. Hang up the receivers of all the telephones in order to complete the learning process
for this MSN.
Deleting Internal Telephone Call Distribution on the ISDN-Point-to-Multipoint
Connection
Requirements:
– Knowledge of the sub-admin or admin PIN
1. Pick up the receiver.
2. Dial ##8.
3. Enter the sub-admin or admin PIN.
4. Dial *900#.
COMpact 3000 analog/ISDN/VoIP - Firmware Version 4.0 - Version of the Manual 03 02/11
451