Auerswald COMpact 3000 analog Installation, Operation And Configuration Instructions page 520

Service and Maintenance
Remote Configuration and Alternative Connection Options
Configuring ISDN System Telephones via the PBX (Internal)
1. Start the COMfortel Set configuration software.
2. Open the menu Options > Interface....
3. Depending on the existing connection, proceed as described in the following.
• USB connection: In the Interface list field, select the USB option.
• USB connection using the CAPI-2.0 driver installed: In the list field Interface,
select the ISDN card (CAPI 2.0) option.
• Ethernet connection via the PBX: In the Interface list field, select the IP network
option, and then in the IP address entry field, enter the IP address of the PBX and
in the IP port (Default: 7002) entry field, enter the configuration port for system
telephones on the PBX.
4. Click OK.
5. Open the menu File > Open.
6. Click Telephone.
The Connection routes dialog opens with the devices connected via the configured
interface.
7. If necessary, double-click the PBX symbol to display all the connected system
telephones. Select the telephone whose configuration you would like to open and click
OK.
The PIN entry dialog opens.
8. Select the desired authorization level from the Authorization level list field.
9. Enter the associated PIN in the PIN entry field and click OK.
The configuration is loaded from the telephone. This may take a while.
10. Make the desired changes.
Once you have configured all the changes to your satisfaction, first save the configu-
ration as described in the following as a file on a storage medium (PC) and then in the
telephone.
11. Open the menu File > Save.
12. Click File.
A file location dialog opens.
13. Select the directory in which you would like to save the file.
520
COMpact 3000 analog/ISDN/VoIP - Firmware Version 4.0 - Version of the Manual 03 02/11