Initiating Reservation Of Exchange Line On Busy; Initiating Internal Callback On No Response - Auerswald COMpact 3000 analog Installation, Operation And Configuration Instructions

Telephoning
Outgoing Calls

Initiating Reservation of Exchange Line on Busy

Initiating Reservation of Exchange Line on Busy
If you hear the busy signal before finishing the dialling process, proceed as described in the
following.
1. Press the Flash key (when using a telephone with DTMF dialling) or the Query key
(when using an ISDN telephone).
2. Dial *37#.
You will hear the confirmation tone.
3. Hang up the receiver.
As soon as a line is available, you will be called back by the PBX.
4. Pick up the receiver.
You will hear the external dial tone.
5. Dial an external telephone number without an exchange line access number.
Note: When using ISDN telephones, you cannot dial directly after picking up
the receiver of the ringing telephone (callback of the PBX). After picking up
the receiver when the telephone rings, you will hear the confirmation tone
instead of the external dial tone. Put down the receiver and pick it up again
immediately. You can now dial as usual.

Initiating Internal Callback on No Response

If no one answers on the connection you are calling, proceed as described in the following.
1. Press the Flash key (when using a telephone with DTMF dialling) or the Query key
(when using an ISDN telephone).
2. Dial *37#.
You will hear the confirmation tone.
3. Hang up the receiver.
As soon as the connection has been used, you are called by the PBX for a period of
20 seconds.
4. Pick up the receiver to the make the callback.
106
COMpact 3000 analog/ISDN/VoIP - Firmware Version 4.0 - Version of the Manual 03 02/11