Remote Configuration And Alternative Connection Options; Possible Connection Options For Configuring The Pbx And The Connected Isdn System Telephones - Auerswald COMpact 3000 analog Installation, Operation And Configuration Instructions

Service and Maintenance

Remote Configuration and Alternative Connection Options

Possible Connection Options for Configuring the PBX and the Connected ISDN System Telephones

Remote Configuration and Alternative
Connection Options
Aside from configuration over the internal network, there is also the option of remote configu-
ration via the Internet as well as configuring alternative connection options under certain condi-
tions.
The connected system telephones can also be configured over the PBX under certain condi-
tions.
Possible Connection Options for Configuring the PBX and the Connected ISDN
System Telephones
The following connection options are possible for configuring or remotely configuring the PBX
and the connected ISDN system telephones:
Configuration of the PBX via the Internal Network
The PBX is normally configured via an internal network connection. The PC used for this must
be located on the same network as the PBX.
Remote Configuration of the PBX via the Internet
The PBX can be configured remotely via an Internet connection (DSL). This requires a
permanent external IP address or alternatively VPN or DynDNS. The routers on the PBX
network must be configured for this purpose accordingly.
Configuration of the PBX via an Internal S
Important: This function is only possible with the COMpact S
COMpact ISDN module available as an option.
The PBX can only be configured over an indirect internal or external ISDN connection on a
device that is not only connected to an internal S
controller or Auerswald USB device). The PBX must be configured for this purpose accordingly.
A dial-up connection must also have been previously configured on the PC.
COMpact 3000 analog/ISDN/VoIP - Firmware Version 4.0 - Version of the Manual 03 02/11
Port (PPP Internal)
0
port on the PBX but also to a PC (ISDN PC
0
module or
0
513