Configuring Dealer Access Numbers - Auerswald COMpact 3000 analog Installation, Operation And Configuration Instructions

Service and Maintenance
Remote Configuration and Alternative Connection Options

Configuring Dealer Access Numbers

2. Enter an internal telephone number in the Internal CAPI dial-in number entry field
under Configuration (PPP internal). The following entries are possible:
2 to 4 digits in the range of 10 to 9999
Note:
Double allocation of a number is not possible.
The telephone numbers 70, 80, 87, 701-706, 801-806, 875-879 and 8750-
8799 cannot be freely allocated. They are required for internal PBX use.
Using telephone numbers with few digits (two or three-digit numbers) inevi-
tably restricts the possible supply of telephone numbers requiring more
digits. For example, if the telephone number 12 is assigned, the telephone
numbers 120-129 and 1200-1299 are no longer available.
The default exchange line access number on the PBX is "0" in the factory
settings; however, this can be changed. Note that changing the exchange
line access number restricts the telephone number plan.
Further steps:
– Save your settings before you leave the page.
Configuring Dealer Access Numbers
The dealer access numbers indicate from which connections the PBX can be remotely confi-
gured without manual activation. For this purpose, the PC connected to the PBX via an external
ISDN connection must transmit one of the entered dealer access numbers.
Note: If no dealer access number has been configured or the telephone
number transmitted does not correspond with the configured telephone
numbers, the PBX must be activated via an internal telephone using a digit
sequence for remote configuration.
The configuration can be made as follows:
• Via the configuration manager
Requirements:
– Configuration manager, opened with sufficient authorization
– Expert view (click
COMpact 3000 analog/ISDN/VoIP - Firmware Version 4.0 - Version of the Manual 03 02/11
)
529