Switching Routing For Cf Via Exception Telephone Numbers On/Off - Auerswald COMpact 3000 analog Installation, Operation And Configuration Instructions

Configuring and Operating Functions
VoIP/GSM Routing

Switching Routing for CF via Exception Telephone Numbers On/Off

ISDN connection: The dial attempt is made over the ISDN connection (only for
the COMpact 3000 ISDN).
ISDN connection ISDN module: The dial attempt is made over the ISDN
connection (only on the COMpact ISDN module available as an option).
Analog connection: The dial attempt is made over the analog connection
(only for the COMpact 3000 analog).
8. Under Configurations, select or clear the check box for the configurations listed on
the page.
Enables the exception telephone number for the configuration in question.
Disables the exception telephone number for the configuration in question.
9. Repeat step 2 to 8 to enter additional exception telephone numbers.
Further steps:
– Save your settings before you leave the page.
Switching Routing for CF via Exception Telephone Numbers On/Off
If routing for CF via exception telephone numbers is enabled, a check is made as to whether
the destination number has been entered as an exception telephone number. If this is the case,
the call is forwarded over the configured path. If the destination number has not been entered
in the routing table, the PBX uses the available call channel that belongs to the port.
Switching on/off of the routing is only possible for call forwarding for externel numbers.
Switching this on/off can be done as follows:
• Via the configuration manager
Requirements:
– External analog port (only COMpact 3000 analog), external S
COMpact 3000 ISDN or COMpact ISDN module available as an option) or external VoIP
channel
– Configuration manager, opened with sufficient authorization
– Configured exception numbers (VoIP/GSM routing)
– Expert view (click
1. Open the page CONFIGURATION > External numbers.
2. In the list field at the top, select the connection in question.
COMpact 3000 analog/ISDN/VoIP - Firmware Version 4.0 - Version of the Manual 03 02/11
)
port (only
0
319