Configuring The External Pin - Auerswald COMpact 3000 analog Installation, Operation And Configuration Instructions

Service and Maintenance
Remote Configuration and Alternative Connection Options

Configuring the External PIN

The configuration can be made as follows:
• Via the configuration manager
Requirements:
– Configuration manager, opened with sufficient authorization
– Expert view (click
1. Open the page CONFIGURATION > Server configuration > Network.
2. Enter the IP address in the Local IP address entry field under PPP configuration.
The following entries are possible:
IP address with a range of 0 to 255 (example: 103.103.103.103)
3. Enter the IP address in the Remote IP address entry field under PPP configuration.
The following entries are possible:
IP address with a range of 0 to 255 (example: 103.103.103.103)
Further steps:
– Save your settings before you leave the page.
Configuring the External PIN
The external PIN is required for the following:
• Perform a configuration switchover manually via an external telephone
• Monitor a room via an external telephone
• A dial-up connection for initiating remote configuration on the PBX if the user name
"external" is used
The configuration can be made as follows:
• Via the configuration manager
• Using a character string on the internal telephone
Configuring an External PIN via the Configuration Manager
Requirements:
– Configuration manager, opened with sufficient authorization
– Expert view (click
524
)
)
COMpact 3000 analog/ISDN/VoIP - Firmware Version 4.0 - Version of the Manual 03 02/11