Configuring A User Name And Password - Auerswald COMpact 3000 analog Installation, Operation And Configuration Instructions

Configuring and Managing the PBX
VoIP

Configuring a User Name and Password

4. Open the page CONFIGURATION > External phone numbers > VoIP connection
> Name and settings.
5. In the list field at the top, select the account in question by its name.
6. Enter an internal telephone number for the account in the Exchange line access
number (account number) entry field. The following entries are possible:
2 to 4 digits in the range of 10 to 9999
Note:
Double allocation of a number is not possible.
During the initial configuration in the configuration wizard, the exchange line
access number (account number) 8000 for the VoIP account is automatically
allocated.
The telephone numbers 70, 80, 87, 701-706, 801-806, 875-879 and 8750-
8799 cannot be freely allocated. They are required for internal PBX use.
Using telephone numbers with few digits (two or three-digit numbers) inevi-
tably restricts the possible supply of telephone numbers requiring more
digits. For example, if the telephone number 12 is assigned, the telephone
numbers 120-129 and 1200-1299 are no longer available.
The default exchange line access number on the PBX is "0" in the factory
settings; however, this can be changed. Note that changing the exchange
line access number restricts the telephone number plan.
Further steps:
– Save your settings before you leave the page.
Configuring a User Name and Password
The user name is allocated during account configuration and is used as identification by the
VoIP provider. The password is used to verify the user name.
Note:
Note that some providers allocate both login information for the web page
and separate login information for using the Voice over IP service (e.g., a
dial-in password). Find out what information is needed for the dial-in and
enter it accordingly.
COMpact 3000 analog/ISDN/VoIP - Firmware Version 4.0 - Version of the Manual 03 02/11
427