Connecting Both Communication Partners; Initiating A Query Call To Third Subscriber - Auerswald COMpact 3000 analog Installation, Operation And Configuration Instructions

Telephoning
Query Calls

Connecting Both Communication Partners

Connecting Both Communication Partners
Requirements:
– Initiated query call
– To connect two external communication partners, the following is required: Authorization
Transfer of external calls to external assigned to the subscriber
During a query call, proceed as described in the following.
• Hang up the receiver.
Both communication partners are connected with each other.

Initiating a Query Call to Third Subscriber

Requirements:
– Initiated query call
During a query call, proceed as described in the following.
1. Press the Flash key (when using a telephone with DTMF dialling) or the Query key
(when using an ISDN telephone).
2. Dial 5.
3. Enter a telephone number. The following entries are possible:
** and internal telephone number of the individual telephone (If you do not
use a direct exchange line access, omit the **.)
** and internal telephone number of the line group (If you do not use a
direct exchange line access, omit the **.)
External telephone number (If you do not use a direct exchange line access,
dial the exchange line access number before dialling the telephone number.)
** and short code number (If you do not use a direct exchange line access,
omit the **.)
As soon as to the subscriber being called picks up the receiver, you will make a third
call.
112
COMpact 3000 analog/ISDN/VoIP - Firmware Version 4.0 - Version of the Manual 03 02/11