Auerswald COMpact 3000 analog Installation, Operation And Configuration Instructions page 75

Installing and Switching on the PBX
Commissioning
Putting VoIP System Telephones into Operation
Note: The prerequisite for the execution described here is that the telephone
be operated as a DHCP client in the network. If this is not the case, refer to
the Commissioning Instructions for the telephone.
1. Connect end devices with a separate power supply to the 230 V mains.
2. Select the language.
3. Enter the internal telephone number as an MSN for the end device.
4. If it is configured, enter the user PIN for the end device.
The end device searches for the PBX.
5. Confirm the displayed IP address for the PBX.
The end device logs on to the PBX.
COMpact 3000 analog/ISDN/VoIP - Firmware Version 4.0 - Version of the Manual 03 02/11
75