Auerswald COMpact 3000 analog Installation, Operation And Configuration Instructions page 445

Configuring and Managing the PBX
DECT System Telephones
Copying a Telephone Book Selection into Other Mobile Handsets
Requirements:
– Internal S port (only provided on the COMpact S
0
available as an option)
– Configuration manager, opened with sufficient authorization
– Configured internal telephone numbers for the base station
– Assigned internal telephone numbers for the mobile handsets
– Telephone numbers selected in the telephone book for transmission for the source
subscriber
1. Open the page CONFIGURATION > Internal numbers > ISDN subscribers.
2. Click DECT settings.
3. Open the page Copy COMfortel DECT 900.
4. In the list field at the top, select the mobile handset, whose telephone book selection
should be copied based on its name/number.
5. Select or clear the Transmission of telephone numbers to the destination
telephone check box.
Enables transmission.
Disables transmission.
6. Under Destination, select or clear the check box next to the internal telephone
numbers for the mobile handsets into which the telephone book selection should be
copied.
Enables the mobile handset as the destination.
Disables the mobile handset as the destination.
7. Click Copy.
Note: The PBX begins to distribute the data to the mobile handsets in
question. If a mobile handset is currently not ready for the data transfer
(disabled, out of range or busy with a call), the PBX makes an attempt with
the next mobile handset after a few minutes until all of the data is distributed.
During the data transfer (duration: up to two minutes), the mobile handset is
not available and "Copying from PBX" is shown on the display.
COMpact 3000 analog/ISDN/VoIP - Firmware Version 4.0 - Version of the Manual 03 02/11
module or COMpact ISDN module
0
445