Configuring Isdn System Telephones Via The Pbx (Internal) - Auerswald COMpact 3000 analog Installation, Operation And Configuration Instructions

Service and Maintenance
Remote Configuration and Alternative Connection Options

Configuring ISDN System Telephones via the PBX (Internal)

6. Enter http:// and the local IP address of the PBX (factory setting: 192.168.193.240)
in the address field of the browser.
The login window opens.
7. Enter your user name and PIN.
Note: The PIN entered here determines the authorization level for the confi-
guration. The external PIN cannot be used here.
8. Click Log in.
The configuration manager opens.
9. Make the desired changes.
Note: When the PBX is restarted, the dial-up connection disconnects and
you must dial into the PBX again.
10. Once you have completely configured the PBX, click Logout.
11. Then, disconnect the dial-up connection. To do this, right-click the connection symbol
in the task bar, click Disconnect or Disconnect from and then select the name of
the connection.
Configuring ISDN System Telephones via the PBX (Internal)
Requirements:
– Installed COMfortel Set configuration software as of version 2.5
– Knowledge of the user, sub-admin or admin PIN
– An existing Ethernet connection between the PC and the PBX or a USB connection on the
PC to one of the internal system telephones including the complete installation of the drivers
required for the device on the PC
Note: For a USB connection, this refers to the USB driver and possibly the
CAPI-2.0 driver. To install the drivers, refer to the driver installation and
Internet access instructions (CAPI/TAPI) that came with the device.
– For the Ethernet connection between the PC and the PBX: Configured configuration port for
system telephones
COMpact 3000 analog/ISDN/VoIP - Firmware Version 4.0 - Version of the Manual 03 02/11
519