Configuring Clip Amplification - Auerswald COMpact 3000 analog Installation, Operation And Configuration Instructions

Configuring and Managing the PBX
Analog Connection

Configuring CLIP Amplification

Requirements:
– External analog port (only COMpact 3000 analog)
– CLIP service attribute enabled with the network provider (telephone number display)
– Configuration manager, opened with sufficient authorization
– Expert view (click
– Configured prefixes (country prefix and local area code)
1. Open the page CONFIGURATION > External numbers.
2. In the list field at the top, select the analog connection.
A page opens for configuring the analog connection.
3. Open the page Analogue connection > Expert configuration.
4. In the CLIP sub-version list field under CLIP, select when the CLIP information will
be sent by the network provider.
Note: By selecting the No CLIP information evaluation option, the data sent
by the network provider is not passed on to the internal subscribers.
Further steps:
– Save your settings before you leave the page.
Configuring CLIP Amplification
The amplification of the CLIP information indicates the number of decibels all audio signals are
increased or decreased by the PBX while receiving CLIP information.
The configuration can be made as follows:
• Via the configuration manager
Requirements:
– External analog port (only COMpact 3000 analog)
– CLIP service attribute enabled with the network provider (telephone number display)
– Configuration manager, opened with sufficient authorization
– Expert view (click
– Configured prefixes (country prefix and local area code)
382
)
)
COMpact 3000 analog/ISDN/VoIP - Firmware Version 4.0 - Version of the Manual 03 02/11