Auerswald COMpact 3000 analog Installation, Operation And Configuration Instructions page 62

Installing and Switching on the PBX
ISDN End Devices
Connecting the Cable and the Wall Sockets to the Internal S
3. Connect the IAE or UAE8 sockets to the terminal clamps at the internal S
The figure below shows the wiring of the terminal clamps with different wall sockets
(IAE and UAE8) in a diagram, as well as the position of the terminators in the last wall
socket.
4. Equip the last wall socket with two terminators.
Note: For a short passive bus in two directions, equip the wall sockets on both
ends with terminators.
Further steps:
– Connect the end devices to the wall sockets.
62
Port (Internal S
0
COMpact 3000 analog/ISDN/VoIP - Firmware Version 4.0 - Version of the Manual 03 02/11
Bus)
0
port.
0