Configuring A Dial-Up Connection On The Pc - Auerswald COMpact 3000 analog Installation, Operation And Configuration Instructions

Service and Maintenance
Remote Configuration and Alternative Connection Options

Configuring a Dial-up Connection on the PC

1. Open the page SERVICE > Remote configuration.
2. In the entry fields Dealer access number 1 to Dealer access number 4 under
Authorization for remote configuration (PPP), enter one external telephone
number along with the local area code in each field (local dialling code). The following
entries are possible:
Up to 20 digits
Digits
Further steps:
– Save your settings before you leave the page.
Configuring a Dial-up Connection on the PC
The PBX supports the transmission of configuration data by remote data transmission (dial-up).
This can take place over an indirect internal or external ISDN connection on a device that is not
only connected to an internal or external S
controller or Auerswald USB device). The PBX must be configured for this purpose accordingly.
A dial-up connection must also have been previously configured on the PC.
Note: The following steps describe how to configure the PC on the operating
systems, Windows XP or Vista. If using another operating system or one with
significant differences to the basic settings, refer to the documentation of your
operating system.
Configuring a Dial-up Connection on Windows XP
Requirements:
– For configuration via the internal S
– For remote configuration via the external S
– Knowledge of the external PIN, the sub-admin PIN or admin PIN
1. Click Start.
2. Click All Programs.
3. Click Accessories.
530
port on the PBX but also to a PC (ISDN PC
0
port: Configured internal CAPI dial-in number
0
port: Configured remote switching number
0
COMpact 3000 analog/ISDN/VoIP - Firmware Version 4.0 - Version of the Manual 03 02/11