Service and Maintenance
Remote Configuration and Alternative Connection Options
Configuring the Configuration Port for System Telephones
Configuring the Configuration Port for System Telephones
The configuration port (factory setting: 7002) for system telephones indicates which port on the
PBX is used by the configuration software on the ISDN system telephone during the trans-
mission.
The configuration can be made as follows:
• Via the configuration manager
Requirements:
– Configuration manager, opened with sufficient authorization
– Expert view (click
1. Open the page CONFIGURATION > Server configuration > Network.
2. Enter a port in the Configuration port for system telephones entry field under
Webserver configuration. The following entries are possible:
1 to 65535
Further steps:
– Save your settings before you leave the page.
Configuring Internal CAPI Dial-in Numbers
The Internal CAPI dial-in number is a telephone number that has been taken from the internal
telephone number plan and is used as a dial-up phone number for a dial-up connection. This
is used to configure the PBX remotely using an internal ISDN connection.
The configuration can be made as follows:
• Via the configuration manager
Requirements:
– Configuration manager, opened with sufficient authorization
– Expert view (click
1. Open the page SERVICE > Remote configuration.
528
)
)
COMpact 3000 analog/ISDN/VoIP - Firmware Version 4.0 - Version of the Manual 03 02/11