Auerswald COMpact 3000 analog Installation, Operation And Configuration Instructions page 150

Managing Voice Mailboxes and Fax Boxes
Voice Mailbox
Switching a Voice Mailbox On/Off
3. In the Voice mailbox list field, select the voice mailbox you want in column of the
corresponding telephone number.
Note: Click
creating voice mailboxes.
4. Only when on no reply or on no reply + on busy under Voice mail function has
been selected: Open the page CONFIGURATION > Call distribution > Settings and
enter a value in the Delay time for voice mailboxes entry field. The following entries
are possible:
1 to 60: The voice mailbox accepts an incoming call on no reply after 1 to 60
seconds.
Note: The Delay time for voice mailboxes setting applies to all of the voice
mailboxes.
Further steps:
– The default announcement is played back according to the factory settings. If there is already
other announcements for your voice mailboxes, select the desired announcement from the
Announcement list field.
– Select or clear the Recording check box.
– Save your settings before you leave the page.
Switching the Voice Mailbox On/Off via an Internal Telephone
Requirements:
– An SD card inserted in the SD card slot or a USB memory stick inserted in the USB port
– Authorization Controlling of the PBX via telephone assigned to the subscriber
– Subscriber is a member of the call distribution group
1. Pick up the receiver of the telephone in question.
2. Dial ##97.
3. Enter the telephone number of the call distribution group. The following entries are
possible:
** and internal telephone number of the call distribution group (If you do
not use a direct exchange line access, omit the **.)
150
next to the Voice mailbox list field to go to the page for
COMpact 3000 analog/ISDN/VoIP - Firmware Version 4.0 - Version of the Manual 03 02/11