Configuring The Display - Auerswald COMpact 3000 analog Installation, Operation And Configuration Instructions

Managing the Telephone Book and Lists
Call Data

Configuring the Display

Configuring the Display
The call data recorded in the call data memory can be displayed in the call data list or printed
out. This allows you to select the data to be displayed, and create separate labels for the table
columns.
The configuration can be made as follows:
• Via the configuration manager
Requirements:
– Configuration manager, opened with sufficient authorization
– Expert view (click
1. Open the page FUNCTIONS > Call data > Display.
2. Select which data should be displayed or not:
• Call data list: Select or clear the corresponding check box in the column
display the call data in a separate column in the call data list.
• Printout: Select or clear the corresponding check box in the column
Enables the output.
Disables the output.
Note:
The data for LCRNr (LCR number), Scr no. invoice (Int. subscriber
(invoice)), Billing (Billing factor), types of billing bus. (Business)/private
(Private) and Type of call are always displayed in the Info column of the
call data list.
All call data that has not been enabled for display in the call data list is
displayed in the Info column of the call data list.
3. Enter the desired text in the entry fields under New description. The following entries
are possible:
Digits and characters
Up to 16 digits
Further steps:
– Save your settings before you leave the page.
136
)
COMpact 3000 analog/ISDN/VoIP - Firmware Version 4.0 - Version of the Manual 03 02/11
to
.