Configuring Calls To Be Recorded For The Call Data List - Auerswald COMpact 3000 analog Installation, Operation And Configuration Instructions

Managing the Telephone Book and Lists
Call Data

Configuring Calls to be Recorded for the Call Data List

2. In the list field at the top, select the subscriber in question by his name or number.
3. Select or clear the When the call data memory has reached capacity check box
under Special dial tone.
Enables the special dial tone when the call data memory has reached the
specified capacity.
Disables the special dial tone.
4. Open the page FUNCTIONS > Call data > Memory use.
5. Enter a value in the Special dial tone when call data memory is full entry field
under Memory full. The following entries are possible:
1 to 100 percent.
Further steps:
– Save your settings before you leave the page.
Configuring Calls to be Recorded for the Call Data List
The calls to be recorded can be selected in order to prevent the call data memory from filling
up too quickly.
Note: The transmission of the charge information can be disabled for an
ISDN connection (CONFIGURATION > External phone numbers > ISDN
connection > Name and functions).
The following subgroups can be recorded:
• Chargeable calls: Outgoing chargeable calls and failed outgoing calls for which charges
have accrued (e.g., for CF via the network provider (transfer charge)
• Free of charge/calls without charge information: Outgoing calls that are free of charge
or for which no charge information is transmitted
– Successful only: Only outgoing calls that are free of charge or for which no charge
information is transmitted (failed calls are not recorded)
• Private calls with partial telephone number privacy: Due to reasons of privacy
protection, the transparency of external telephone numbers during outgoing private calls
can be dispensed with. When this is done, the last three digits of the telephone number
dialled is displayed as asterisks (*). The remaining data from each call will continue to be
recorded.
138
COMpact 3000 analog/ISDN/VoIP - Firmware Version 4.0 - Version of the Manual 03 02/11