Auerswald COMpact 3000 analog Installation, Operation And Configuration Instructions page 518

Service and Maintenance
Remote Configuration and Alternative Connection Options
Configuring the PBX Remotely via an External S
Note: The external PIN may also be used for the dial-up connection. The user
PIN can also be used to log in.
– An existing external ISDN connection between the PC and the PBX over an Auerswald USB
device (e.g., COMfortel 2500) or an ISDN PC controller including the complete installation of
the drivers required for the device on the PC
Note: For an Auerswald USB device, this refers to the USB, the CAPI-2.0 and
CoNDIS-WAN drivers. To install the drivers, refer to the driver installation and
Internet access instructions (CAPI/TAPI) that came with the device.
– The dial-up connection configured on the computer
– Release the PBX immediately before remote configuration if no dealer access number has
been configured or the transmission of the configured numbers is not possible on the
computer being used.
Note: The following steps describe how to configure the settings on the
operating systems, Windows XP, Vista and 7. If using another operating
system or one with significant differences to the basic settings, refer to the
documentation of your operating system.
1. Click Start.
2. Depending on the operating system, proceed as described in the following.
• Windows XP: Click Connect to and then select the name of the connection.
• Windows Vista: Click Connect to, then select the name of the connection, and
then finally click Connect.
• Windows 7: Click Control Panel, Connect to the Internet, then select the name
of the connection, and then finally click Next.
The connection dialog window now opens.
3. Under Password, enter the PIN for the user name displayed.
4. Click Dial.
The connection symbol (one monitor/two monitors) in the task bar (to the left next to
the time) indicates whether the connection is active.
5. Start a browser (e.g., Mozilla Firefox).
518
Port (PPP External)
0
COMpact 3000 analog/ISDN/VoIP - Firmware Version 4.0 - Version of the Manual 03 02/11