Restarting The Tapi Server; Checking The Function Of The Lan-Tapi - Auerswald COMpact 3000 analog Installation, Operation And Configuration Instructions

Configuring and Operating Functions
LAN-TAPI

Restarting the TAPI Server

1. Start the Auerswald Mega Disk on the server PC.
2. Open the software page for the COMpact 3000. Click TAPI service providers under
Drivers.
The TAPI driver installation is started.
3. Follow the installation by clicking Next.
4. Depending on the driver version, the driver may need to be activated at this point. If
you do not yet want to activate it, click the Später freischalten button.
5. In the IP address of the PBX entry field, enter the IP address of the PBX. Enter the
network port of the TAPI server in the Port entry field. Enter the password for the
network connection of the TAPI server in the Password and Repeat password entry
fields. Click OK.
6. Click Close.
7. Restart the PC.
Restarting the TAPI Server
Performing this procedure can be carried out as follows:
• Via the configuration manager
Requirements:
– Configuration manager, opened with sufficient authorization
– Expert view (click
1. Open the page FUNCTIONS > LAN TAPI > LAN TAPI configuration.
2. Click Restart under Restart TAPI server.
The TAPI server restarts.
Further steps:
– Save your settings before you leave the page.

Checking the Function of the LAN-TAPI

To perform a simple function check of the TAPI driver (TSP) as well as the settings configured
in the PBX, use the dialling help on Windows on the server PC.
250
)
COMpact 3000 analog/ISDN/VoIP - Firmware Version 4.0 - Version of the Manual 03 02/11