Auerswald COMpact 3000 analog Installation, Operation And Configuration Instructions page 79

Using the Configuration Manager
Configuration Manager
Opening the Configuration Manager
environment. The configuration manager is then opened in the browser.
Steps 1 and 2 are omitted. Proceed with Step 3.
1. Start a browser (for example, Mozilla Firefox or Microsoft Internet Explorer).
2. Enter the IP address of the PBX in the address field of the browser (for example,
http://192.168.178.4).
3. Under User name, enter the user name sub-admin.
4. Enter the sub-admin PIN for the sub-administrator under PIN.
5. Click Log-in.
The configuration manager opens.
Note: If the sub-administrator enters his own internal telephone number as
his user name, this log-in is recognized as a user log-in and the Web interface
is displayed for the user.
Further steps:
– Configure the desired settings in sequence (page for page).
Open the configuration manager as an administrator
Requirements:
– An existing Ethernet connection between the PC and the PBX or both the PC and the PBX
on the same network
– Knowledge of the IP address on the PBX
– Knowledge of the admin PIN
Note: If the UPnP service is installed and enabled on the PC being used, the
PBX is identified and selected as the "Auerswald PBX" device in the network
environment. The configuration manager is then opened in the browser.
Steps 1 and 2 are omitted. Proceed with Step 3.
1. Start a browser (for example, Mozilla Firefox or Microsoft Internet Explorer).
COMpact 3000 analog/ISDN/VoIP - Firmware Version 4.0 - Version of the Manual 03 02/11
79