Using The Configuration Wizard - Auerswald COMpact 3000 analog Installation, Operation And Configuration Instructions

Using the Configuration Manager
Configuration Manager

Using the Configuration Wizard

In the expert view, a button with
view. In addition, Expert view is visible next to the PBX name at the top.
Changes can be made as follows:
• Via the configuration manager
Requirements:
– Configuration manager, opened with sufficient authorization
• Click the corresponding letter key:
Switches to the expert view.
Switches to the standard view.
Using the Configuration Wizard
The configuration wizard automatically goes through all of the pages in the configuration
manager that are required for a quick setup on the PBX (e.g., for the initial configuration).
It can be used as follows:
• Via the configuration manager
Requirements:
– Configuration manager, opened with sufficient authorization
1. Open the page CONFIGURATION > Configuration Wizard.
The configuration wizard is started.
Note: Pay attention to the information on the Web interface.
2. Click the corresponding buttons to switch from one page to another in the configu-
ration wizard:
Switches to the following page in the configuration wizard.
Switches to the preceding page in the configuration wizard.
Ends the configuration wizard immediately.
Saves the configured settings.
COMpact 3000 analog/ISDN/VoIP - Firmware Version 4.0 - Version of the Manual 03 02/11
is available for switching to the standard
87