Configuring The Call Duration Of A Wake-Up Call; Configuring A Pause Between Wake-Up Calls - Auerswald COMpact 3000 analog Installation, Operation And Configuration Instructions

Configuring and Operating Functions
Wake-up Functions

Configuring the Call Duration of a Wake-up Call

Configuring the Call Duration of a Wake-up Call
The call duration of a wake-up call indicates how long a single wake-up call is signaled on the
end device.
The configuration can be made as follows:
• Via the configuration manager
Requirements:
– Configuration manager, opened with sufficient authorization
1. Open the page FUNCTIONS > Wake-up functions > Settings.
2. Enter a value in the Call duration of a Wake-up call (30..120 sec.) entry field. The
following entries are possible:
30 to 120: A wake-up call is signaled for 30 to 120 seconds.
Further steps:
– Save your settings before you leave the page.

Configuring a Pause between Wake-up Calls

The pause between wake-up calls indicates how many minutes occur between the first and
second wake-up calls as well as between each the second and the following wake-up calls.
The configuration can be made as follows:
• Via the configuration manager
Requirements:
– Configuration manager, opened with sufficient authorization
1. Open the page FUNCTIONS > Wake-up functions > Settings.
2. Select one of the following options in the Pause between the first and second
wake-up call list field under Pause between wake-up calls.
1 to 15: There is a pause of 1 to 15 minutes between the first and second
wake-up calls.
COMpact 3000 analog/ISDN/VoIP - Firmware Version 4.0 - Version of the Manual 03 02/11
327