Auerswald COMpact 3000 analog Installation, Operation And Configuration Instructions page 151

Managing Voice Mailboxes and Fax Boxes
Voice Mailbox
Switching a Voice Mailbox On/Off
Note:
The telephone number of the call distribution group is found on the page
CONFIGURATION > Call distribution.
A subscriber is a member of a call distribution group if he is assigned to the
call distribution group in the column of the corresponding group telephone
number (
4. Dial one of the following character strings:
#*21#: Enables the voice mailbox via all configurations.
##21#: Disables the voice mailbox via all configurations.
Note: You can also enable or disable the voice mailbox using voice
commands. To configure this, call the voice mailbox internally.
Switching the Voice Mailbox On via an External Telephone
Requirements:
– An SD card inserted in the SD card slot or a USB memory stick inserted in the USB port
– DTMF dialling support on the external telephone
– Imported language file (*.fs)
– Knowledge of the PIN for accessing the corresponding voice mailbox remotely
– Disabled voice mailbox
1. Call the voice mailbox and keep ringing for approximately one minute.
The voice mailbox takes the call. You will be prompted to enter the 6-digit PIN for
remote access and then the pound sign.
2. Enter the PIN for remote query and dial #.
You are in the menu for remote access.
3. Dial *11.
The voice mailbox is enabled.
Further steps:
– If required, execute remote access.
COMpact 3000 analog/ISDN/VoIP - Firmware Version 4.0 - Version of the Manual 03 02/11
or ) on the page CONFIGURATION > Call distribution.
151