Baby Call; Switching Baby Call On/Off - Auerswald COMpact 3000 analog Installation, Operation And Configuration Instructions

Configuring and Operating Functions

Baby Call

Switching Baby Call On/Off

Baby Call
The baby call function provides a service in which approx. 2 seconds after picking up the
receiver, a telephone number is automatically dialled to call an internal or external subscriber.
This means, no key needs to be pressed. However, if a telephone is dialled manually within the
first 2 seconds, it has priority. It must be noted that on some telephones, the numbers dialled
are not sent immediately when the keys are pressed (often there is approx. a half second
delay).
Switching Baby Call On/Off
Switching this on/off can be done as follows:
• Separately for subscribers
• Separately for configurations
• Via the configuration manager
• Using a character string on the internal telephone
Note: A special dial tone can be configured to uniquely signal an enabled
baby call function when the receiver is picked up.
Switching Baby Call On/Off via the Configuration Manager
Requirements:
– Configuration manager, opened with sufficient authorization
– Expert view (click
1. Open the page PROPERTIES > Internal subscribers > Subscriber properties >
User settings.
2. In the list field at the top, select the subscriber in question by his name or number.
3. Select or clear the Baby call (connection without dialling) check box.
Enables baby call.
Disables baby call. (No other action is required.)
COMpact 3000 analog/ISDN/VoIP - Firmware Version 4.0 - Version of the Manual 03 02/11
)
187