Configuring The Sip Port; Configuring The Sip Session Timer - Auerswald COMpact 3000 analog Installation, Operation And Configuration Instructions

Configuring and Managing the PBX
VoIP

Configuring the SIP Port

Configuring the SIP Port
The SIP Port is a port on the local system that is used as a starting point for the SIP transfer.
Configuration can be carried out as follows:
• Separately for VoIP providers
• Via the configuration manager
Requirements:
– External VoIP channel (COMpact 3000 VoIP or VoIP channels purchased and activated in
the Upgrade Center)
– Configuration manager, opened with sufficient authorization
1. Open the page CONFIGURATION > Voice over IP (VoIP) > VoIP provider.
2. Click in the line of the corresponding VoIP provider.
The Provider configuration opens.
3. Open the page Provider configuration > Network.
4. Enter the SIP port in the SIP port entry field under SIP. The following entries are
possible:
1 to 65535
Note: There must be a different SIP port entered for each VoIP provider
configured.
Further steps:
– Save your settings before you leave the page.

Configuring the SIP Session Timer

The PBX cannot detect whether a call connection is disrupted due to problems on the provider
side. The SIP session timer regularly checks whether the connection still exists.
Configuration can be carried out as follows:
• Separately for VoIP providers
• Via the configuration manager
412
COMpact 3000 analog/ISDN/VoIP - Firmware Version 4.0 - Version of the Manual 03 02/11