Configuring The Pbx Remotely Via An External S Port (Ppp External) - Auerswald COMpact 3000 analog Installation, Operation And Configuration Instructions

Service and Maintenance
Remote Configuration and Alternative Connection Options
Configuring the PBX Remotely via an External S
8. Click Log in.
The configuration manager opens.
9. Make the desired changes.
Note: When the PBX is restarted, the dial-up connection disconnects and
you must dial into the PBX again.
10. Once you have completely configured the PBX, click Logout.
11. Then, disconnect the dial-up connection. To do this, right-click the connection symbol
in the task bar, click Disconnect or Disconnect from and then select the name of the
connection.
Configuring the PBX Remotely via an External S
Important: Before you can configure the PBX remotely via a dial-up
connection, the required configurations must first be made via an internal
network connection.
Requirements:
– External S port (only COMpact 3000 ISDN or COMpact ISDN module available as an
0
option)
– Configured remote switching number
Note: If no remote switching number has been configured, the PBX must be
activated for remote configuration using a digit sequence on an internal
telephone. After this, the PBX is accessible over each associated MSN/DDI.
– Configured dealer access number
Note: If no dealer access number has been configured or the telephone
number transmitted does not correspond with the configured telephone
numbers, the PBX must be activated via an internal telephone using a digit
sequence for remote configuration.
– Configured local and remote IP addresses
– Knowledge of the sub-admin PIN or admin PIN
COMpact 3000 analog/ISDN/VoIP - Firmware Version 4.0 - Version of the Manual 03 02/11
Port (PPP External)
0
0
Port (PPP External)
517