Switching Lcr On The External Connection On/Off - Auerswald COMpact 3000 analog Installation, Operation And Configuration Instructions

Configuring and Operating Functions
LCR

Switching LCR on the External Connection On/Off

4. Make sure you have current LCR data:
• Import data (Soft LCR 4.0)
• Enter data manually (Soft LCR 4.0):
LCR providers
Tariff groups (LCR networks and the corresponding LCR prefixes)
Tariff information (LCR tables)
5. Create the holidays in the calendar on the PBX and enable them for LCR.
Switching LCR on the External Connection On/Off
If LCR is enabled on the external connection, the external port is used for LCR calls.
Note: Manual LCR by dialling a preceding provider area code is always
possible if the network provider supports call-by-call.
Switching this on/off can be done as follows:
• Via the configuration manager
Requirements:
– External analog port (only on the COMpact 3000 analog) or external S
COMpact 3000 ISDN or COMpact ISDN module available as an option)
– Configuration manager, opened with sufficient authorization
– Expert view (click
– Configured prefixes (country prefix and local area code)
1. Open the page CONFIGURATION > External numbers.
2. In the list field at the top, select the connection in question.
A page opens for configuring the connection in question.
3. Open one of the following pages:
• Analogue connection > Name and functions
• ISDN connection > Name and functions
COMpact 3000 analog/ISDN/VoIP - Firmware Version 4.0 - Version of the Manual 03 02/11
)
port (only
0
255