Terminating One Of The Two Calls - Auerswald COMpact 3000 analog Installation, Operation And Configuration Instructions

Telephoning
Query Calls

Terminating One of the Two Calls

Note:
You can also use this function on analog telephones, where it can be
performed via the T-Net function key/menu (see manual for the telephone).
On ISDN and system phones, this function – if available – is performed via
an existing function key or via the menu (see manual for the telephone).
Terminating One of the Two Calls
Requirements:
– Initiated query call
If one of your two communication partners hangs up the receiver, you will remain connected
with the other one.
Alternatively, during a query call, proceed as described in one of the following steps.
• Press the Flash key (when using a telephone with DTMF dialling) or the Query key
(when using an ISDN telephone) and dial 1.
The current call is disconnected.
You will then make an one-to-one call with the communication partner who had previ-
ously been on hold.
• Press the Flash key (when using a telephone with DTMF dialling) or the Query key
(when using an ISDN telephone) and dial 0.
The call in the background will be disconnected.
You will then make an one-to-one call with the communication partner who had previ-
ously been active.
Note:
You can also use this function on analog telephones, where it can be
performed via the T-Net function key/menu (see manual for the telephone).
On ISDN and system phones, this function – if available – is performed via
an existing function key or via the menu (see manual for the telephone).
COMpact 3000 analog/ISDN/VoIP - Firmware Version 4.0 - Version of the Manual 03 02/11
111