Telephoning
Call Waiting Calls
Accepting the Call Waiting Call
The caller receives a busy signal – in as far as no other telephones are called.
Note:
You can also use this function on analog telephones, where it can be
performed via the T-Net function key/menu (see manual for the telephone).
On ISDN and system phones, this function – if available – is performed via
an existing function key or via the menu (see manual for the telephone).
Accepting the Call Waiting Call
Requirements:
– The call waiting function has to be enabled for the subscriber.
If a call waiting call is signaled, proceed as described in the following.
1. Press the Flash key (when using a telephone with DTMF dialling) or the Query key
(when using an ISDN telephone).
2. Dial 2.
You are connected with the caller. Your previous communication partner hears the
hold music.
Note:
You can also use this function on analog telephones, where it can be
performed via the T-Net function key/menu (see manual for the telephone).
On ISDN and system phones, this function – if available – is performed via
an existing function key or via the menu (see manual for the telephone).
98
COMpact 3000 analog/ISDN/VoIP - Firmware Version 4.0 - Version of the Manual 03 02/11