Configuring Flash Time - Auerswald COMpact 3000 analog Installation, Operation And Configuration Instructions

Configuring and Managing the PBX
Analog Connection

Configuring Flash Time

1. Open the page CONFIGURATION > External numbers.
2. In the list field at the top, select the analog connection.
A page opens for configuring the analog connection.
3. Open the page Analogue connection > Expert configuration.
4. In the Apply country settings from list field, select the desired country.
5. Click OK.
For the analog port, the default settings for the country selected are configured under
General info, Line connection, Start of call (outgoing calls), End of the call,
CLIP, Control commands, Tones and Ring signal.
Further steps:
– Save your settings before you leave the page.
Configuring Flash Time
The flash time indicates how many milliseconds the PBX interrupts the voice circuit to trigger
special functions.
The configuration can be made as follows:
• Via the configuration manager
Requirements:
– External analog port (only COMpact 3000 analog)
– Configuration manager, opened with sufficient authorization
– Expert view (click
– Configured prefixes (country prefix and local area code)
1. Open the page CONFIGURATION > External numbers.
2. In the list field at the top, select the analog connection.
A page opens for configuring the analog connection.
3. Open the page Analogue connection > Expert configuration.
COMpact 3000 analog/ISDN/VoIP - Firmware Version 4.0 - Version of the Manual 03 02/11
)
363