Transferring Without Announcement; Placing External Communication Partner In Waiting Loop - Auerswald COMpact 3000 analog Installation, Operation And Configuration Instructions

Telephoning
Transfer

Transferring without Announcement

Transferring without Announcement
Requirements:
– Internal transfer destination
During a call, proceed as described in the following.
1. Press the Flash key (when using a telephone with DTMF dialling) or the Query key
(when using an ISDN telephone).
2. Enter the internal telephone number. The following entries are possible:
** and internal telephone number of the individual telephone (If you do not
use a direct exchange line access, omit the **.)
** and internal telephone number of the line group (If you do not use a
direct exchange line access, omit the **.)
3. Wait until you hear the ring tone.
4. Hang up the receiver.
Once the called subscriber accepts the call, he is connected with the external
subscriber.
Note: If the subscriber being called does not accept the call, the call is trans-
ferred back to your telephone 60 seconds later (your telephone rings). If the
call is not accepted after another 60 seconds, the call will be terminated by
you. If your own telephone has become busy in the meantime, the procedure
will already be canceled after the first 60 seconds and the external call will be
disconnected.

Placing External Communication Partner in Waiting Loop

Requirements:
– Internal transfer destination
If the internal telephone to which you are trying to transfer a call is busy, proceed as described
in the following.
1. Wait.
You will automatically be reconnected with the waiting communication partner.
116
COMpact 3000 analog/ISDN/VoIP - Firmware Version 4.0 - Version of the Manual 03 02/11