Auerswald COMpact 3000 analog Installation, Operation And Configuration Instructions page 51

Installing and Switching on the PBX
Network Provider
Connecting the Ethernet Port with the Internet
nents (e. g. cables and wall sockets). For a reliable support of 100 Mbps, you
need cables and wall sockets of at least Category 5 (CAT5).
– To use DiffServ to prioritize voice packets: DiffServ support on all active network components
available and enabled
– A router that is specifically designed for VoIP data communication (SIP-aware)
Note: If this is not the case, several of the ports on the router necessary for
VoIP data communication must be enabled (RTP port and SIP-UDP ports)
(Port Forwarding/Port Enabling). A list of the ports used in the PBX can be
found in the configuration manager of the PBX under Service > Port
overview.
1. Depending on the PBX variant operated, proceed as follows.
• COMpact 3000 analog and ISDN: Insert the end of the patch cable into the RJ-45
socket „LAN" on the PBX.
• COMpact 3000 VoIP: Insert the end of the patch cable into the RJ-45 socket
„WAN" on the PBX.
2. Insert the other end of the cable into the output socket on the router or into an existing
network outlet.
COMpact 3000 analog and ISDN: The following figure shows the position of the RJ-
45 socket „LAN" at the side of the casing, as well as the set up connection.
COMpact 3000 analog/ISDN/VoIP - Firmware Version 4.0 - Version of the Manual 03 02/11
51