Putting Standard Isdn End Devices Into Operation - Auerswald COMpact 3000 analog Installation, Operation And Configuration Instructions

Installing and Switching on the PBX
Commissioning

Putting Standard ISDN End Devices into Operation

COMpact 3000 VoIP: The following figure shows the position of the RJ-45 sockets at
the side of the casing, as well as the set up connection to the PC.
Note:
Even if the Ethernet port on the PBX is already connected to the internal
network (LAN), you also need to connect the PC to the internal network. For
more information, contact your system administrator.
To configure the PBX via the Ethernet port, the PC and the PBX have to be
connected to the same network. For the first contact to the PBX, consult the
quick commissioning instructions shipped with the unit.
Putting Standard ISDN End Devices into Operation
Requirements:
– The internal telephone number is configured on the S
1. Connect end devices with a separate power supply to the 230 V mains.
2. Enter the internal telephone number as an MSN for the end device.
The end device is ready for operation.
COMpact 3000 analog/ISDN/VoIP - Firmware Version 4.0 - Version of the Manual 03 02/11
port in question.
0
73