Table of Contents
Advertisement
RIP C
OMMANDS
-
IP RIP SEND
PACKET
ip rip send-packet
Overview
Use this command to enable sending RIP packets through the current interface.
Use the no variant of this command to disable this feature.
Syntax
ip rip send-packet
no ip rip send-packet
Default
Send packet is enabled
Mode
Interface Configuration for a VLAN interface.
Usage
This command can only be configured on VLAN interfaces.
Example
This example shows packet sending being turned on for the VLAN interface
vlan4:
awplus#
awplus(config)#
awplus(config-if)#
Related
ip rip receive-packet
Commands
C613-50103-01 REV A
configure terminal
interface vlan4
ip rip send-packet
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
804
Advertisement
Table of Contents
