Ip Rip Send-Packet - Allied Telesis x510-28GTX Command Reference Manual

RIP C
OMMANDS
-
IP RIP SEND PACKET

ip rip send-packet

Overview Use this command to enable sending RIP packets through the current interface.
Use the no variant of this command to disable this feature.
Syntax ip rip send-packet
no ip rip send-packet
Default Send packet is enabled
Mode Interface Configuration for a VLAN interface.
Usage This command can only be configured on VLAN interfaces.
Example This example shows packet sending being turned on for the VLAN interface
vlan4:
awplus#
awplus(config)#
awplus(config-if)#
Related ip rip receive-packet
Commands
C613-50170-01 Rev B
configure terminal
interface vlan4
ip rip send-packet
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
913