Rcp - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

File Management Commands

rcp

Copies a file from a primary to a non-primary switch in a stack and vice versa.
rcp [cmm-b: | slot:] source_filepath [cmm-b: | slot:] destination_filepath
Syntax Definitions
slot
source_filepath
destination_filepath
cmm-b:
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855-U24X, 9000E
Usage Guidelines
•
On OmniSwitch chassis-based switches this command copies any file from the secondary CMM to the
primary CMM.
•
On OmniSwitch stackable switches this command copies a file from any non-primary switch to the
primary switch in a stack. You must specify the slot number on these switches.
Examples
-> rcp 3:/flash/file.txt file.txt
-> rcp /flash/working/file.txt 3:/flash/working/file.txt
-> rcp cmm-b:/flash/file.txt file.txt
-> rcp /flash/working/file.txt cmm-b:/flash/working/file.txt
Release History
Release 6.1; command was introduced.
OmniSwitch CLI Reference Guide
The slot number of the non-primary switch in a stack.
The name and path of the source file.
The name and path of the destination file.
Specifies the secondary CMM. This parameter is available on
OmniSwitch chassis-based switches only.
June 2012 page 58-33