Fsck - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

fsck

Performs a file system check, including diagnostic information in the event of file corruption.
fsck /flash [no-repair | repair]
Syntax Definitions
/flash
no-repair
repair
Defaults
parameter
no-repair | repair
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
The file system check is performed on the /flash directory by default.
•
Specifying the parameter repair along with the command performs the file system check and also
repairs any errors found.The switch will display the errors found and specify those errors that have
been repaired. If there are no errors found, then just the file system information is displayed.
•
This command only applies to the primary and secondary CMM in an OmniSwitch chassis-based
switch or the primary and secondary switch in an OmniSwitch stack.
Examples
-> fsck /flash no-repair
/flash/ - disk check in progress ...
/flash/ - Volume is OK
total # of clusters:
# of free clusters:
# of bad clusters:
total free space:
max contiguous free space:
total bytes in files:
# of lost chains:
total bytes in lost chains:
page 58-30
Indicates that the file system check will be performed on the /flash
directory.
Performs only the file system check on the /flash directory.
Performs file system check on the /flash directory and also repairs any
errors found on the file system.
default
no-repair
29,758
18,886
0
77,357,056
55,451,648 bytes
# of files: 59
# of folders: 5
44,357,695
0
0
File Management Commands
OmniSwitch CLI Reference Guide June 2012