Renesas RL78 Series User Manual page 743

RL78/G1D
22.4 Operation of Voltage Detector
22.4.1 When used as reset mode
Specify the operation mode (the reset mode (LVIMDS1, LVIMDS0 = 1, 1)) and the detection voltage (V
option byte 000C1H.
The operation is started in the following initial setting state when the reset mode is set.
● Bit 7 (LVISEN) of the voltage detection register (LVIM) is set to 0 (disable rewriting of voltage detection level
register (LVIS))
● The initial value of the voltage detection level select register (LVIS) is set to 81H.
Bit 7 (LVIMD) is 1 (reset mode).
Bit 0 (LVILV) is 1 (low-voltage detection level: V
● Operation in LVD reset mode
In the reset mode (option byte LVIMDS1, LVIMDS0 = 1, 1), the state of an internal reset by LVD is retained until
the supply voltage (V
released when the supply voltage (V
At the fall of the operating voltage, an internal reset by LVD is generated when the supply voltage (V
below the voltage detection level (V
Figure 22-5 shows the timing of the internal reset signal generated in the LVD reset mode.
R01UH0515EJ0120 Rev.1.20
Dec 16, 2016
) exceeds the voltage detection level (V
DD
) exceeds the voltage detection level (V
DD
).
LVD
CHAPTER 22 VOLTAGE DETECTOR
).
LVD
) after power is supplied. The internal reset is
LVD
) by using the
LVD
).
LVD
) falls
DD
722